Reinforced Leveling Foot with special Threaded Plug for iHandle column. The height of the leveling foot, including the plug, when fully tightened, is 27mm (2.7cm). An essential component for the iHandle column, it helps you level the columns regardless of your floor’s evenness.

Screw thread length: 70mm

Usable leveling foot height: 50mm

Leveling foot height (fully tightened): 27mm

Installation Instructions:

1) Place two rosettes on the column with the hooks facing the ground and not towards the ceiling. Tap lightly with a hammer to secure them.

2) Insert the threaded part into the column by tapping lightly with a hammer, then screw the leveling foot onto the threads.

3) Position the column against the wall, adjust the leveling foot as needed, and mark the rosette holes with a pencil.

4) Remove the column and drill.

5) Install the appropriate wall plugs (for plasterboard or solid wall).

6) Reinstall the column with the rosettes and screw into the installed wall plugs.

Note: This specific iHandle 40*40 system is an optimal solution for increased loads, as the loads are transferred to the floor, not the wall.